• 29Oct
    Categories: Automotive, Motorcycles Comments Off on How to Remove Rust From a Motorcycle Gas Tank

    One of the benefits of being to able to paintings on bikes is that you may commonly locate them pretty cheap when paintings on them is required. Typically, a bike that desires work has been sitting for some time, commonly with the tank empty. This method through the years that rust has taken over, as turned into the case with a 1981 Honda CB650 that I had obtained. To say that this factor had rust in it become an underestimation; it had chunks of rust. Luckily although, the tank had no pin hollow leaks or some thing and become absolutely solid. Now to the amusing part! I will provide an explanation for the manner of putting off rust from a motorbike gasoline tank. As I stated, this changed into completed on a eighty one’ CB650, so it’s tailored to that, but I’m positive it will paintings on maximum other motorcycles.

    What you will want:

    Distilled water (it is critical which you simplest use distilled water)
    Two stroke oil
    A period of chain four to 6 toes lengthy
    Something to plug the gas outlet (I used a small piece of hose a small rag and a chunk of black tape)

    IMPORTANT NOTE: ACETONE AND RUBBER DO NOT MIX! If you use rubber to seal the gas output replace it every time you drain the acetone mix as the acetone will devour away at it.

    At this point I’m going to count on which you have the gas tank off the motorcycle and that it’s empty. Here is a grade by grade.

    Plug the fuel output and make certain it’s far sealed
    Fill the tank about ½ complete of acetone and allow it sit turning once in a while
    Wait in a single day
    Shake the tank and empty the acetone/rust aggregate right into a bucket
    Fill the tank ½ way once more with acetone and this time drop the chain in
    Shake the tank regularly and vigorously. The chain will knock last rust off
    Empty the acetone/rust mixture into the bucket
    Fill the tank up with distilled water and empty it out. Do this till most effective pretty smooth water comes out and no rust may be heard rattling round. I put a hairdryer in the fuel hole and dried it out right away after
    Fill the tank approximately ¼ with stroke oil and shake it round then empty it
    Please eliminate the acetone and different nasty chemical substances well

    I fantastically endorse putting in an inline gas filter on the gas line in among the tank and carburetor. It will filter any small particles and hold them out of the fuel system. This gadget labored for me, my CB650 ran like a dream after cleaning the tank like this! The subsequent step is to offer the carb an excellent cleaning.